NORTON EQUIPMENT CO. · (662) 838-7900 · nortonequipmentco.com

Baler operator training checklist

Train on the specific machine using the manufacturer’s manual and your facility’s written procedures. This checklist records that each topic was covered and demonstrated; it does not replace the manual, a lockout/tagout procedure, or the Department of Labor notice required when workers under 18 load the machine. No one under 18 may operate or unload a baler.

Facility / location:
Machine make / model / serial:
Operator name:
Operator date of birth confirmed 18 or older (operate/unload) or 16 to 17 (load only):
Trainer name:
Training date / retraining due:

Topics covered and demonstrated

TopicOperator can demonstrateCovered (initials)Demonstrated (initials)
Pre-shift inspectionGuards, door, latch, interlock intact; emergency stop reachable; no fluid on floor; wire on hand
Controls and emergency stopNames every control; stops the ram; hits the emergency stop from the operating position
Approved material and loading limitsLoads only rated material, flattened, below the fill line; hands and arms stay outside the chamber
The chamber is off limitsStates the rule: nothing enters the chamber while the machine is energized
Full-bale indicationRecognizes the full-bale light, gauge, or ram position and stops loading
Wire tyingThreads ties from outside, twists off correctly, uses the required number of ties, wears eye protection
Bale ejectionRam up and machine stopped before opening the door; stands clear of the tip path; uses the ejector
Bale handlingOnly forklift-certified employees move bales; stacks within the facility limit
Jams and faultsStops, removes the key, reports; never reaches in or bypasses the door switch
Stop conditionsNames them: ram drift or stall, door will not latch, interlock does not stop the cycle, leak, new noise, burning smell, any failed safety device
Housekeeping and PPEKeeps floor and door swing clear; cut-resistant gloves and eye protection for wire
Lockout/tagout awarenessAuthorized operators: performs the written procedure. All others: recognizes a lockout and never starts a locked-out machine
Authorized to operate this machine (yes / no / load only):
Operator signature:
Trainer signature:
Supervisor signature:

Retrain after any incident or near miss, when the machine or procedure changes, when the job assignment changes, and at least annually. Keep this record with the machine’s lockout/tagout procedure and inspection records.